Memphis Auto Repair

When you are pointing your vehicle straight down the street, it should go straight.  That’s pretty straightforward, right? Sometimes, though, you may notice you have to keep adjusting the steering wheel to keep going straight.  While that could be caused by many different issues, one possibility is that you have a failing or bent control arm. Another sign is that when you brake, your vehicle pulls to one side or the other.  Sometimes your suspension may sound noisy, especially when you’re traveling on rough surfaces.  A damaged control arm may also make it almost impossible for you to get a good wheel alignment.  The control arms are part of your suspension, and some vehicles have upper control arms and lower control arms.  Not all have the same number of control arms, but one thing is important: If you have worn bushings on your control arms or a worn-out ball joint, the control arm on the other side should also be replaced.  The rubber b ... read more

There are some boots that don't come in a shoe box and aren't worn on your feet.  They are called axle or CV boots, and they can be important parts for many vehicles. That CV stands for constant velocity.  CV axles are mainly used in front-wheel drive and all-wheel drive vehicles. They're also used in some rear-wheel drive vehicles with independent suspensions.  They have two CV joints, one inner and one outer, placed between the axle and the drive wheels.  That way the vehicle's engine power can drive the wheels, no matter what angle they are.  They also adjust for the different speeds wheels turn as they go around corners.  Because roads are full of all sorts of hazards (dirt, oil, water, grime), these CV joints need to be protected.  They also have grease in them to keep the bearings moving smoothly.  That's the job of the rubber boots that are supposed to keep that debris out.  These CV or axle boots are made of rubber or plastic and usu ... read more